Emissions

EPA Approved, emission product cleaning

DPF (Diesel Particulate Filter) CLEANING

  1. Visually inspect for damage, oil and antifreeze contamination while at your facility.
  2. Check the unit for breaches by using our Magnehelic Inspection station to set a vacuum and take readings.
  3. The unit is pre-cleaned by setting a vacuum and blowing compressed air to make ready for entry into our regeneration oven.
  4. Placing the unit in the oven and setting it to gradually heat up, baking the unit at 1112 degrees Fahrenheit.
  5. Product stays in the oven at 1112 degrees for 2 hours and then gradually cools down.
  6. Total regeneration time is 8 hours.
  7. We remove the unit from the oven, placing it back into our Magnehelic station for final vacuum and compressed air cleaning and take final reading.
  8. The unit is brushed and cleaned externally to ensure a thorough cleaning externally.

DOC (Diesel Oxidation Catalyst) CLEANING

  1. Visually inspect for damage, oil and antifreeze contamination while at your facility.
  2. The unit is pre-cleaned by setting a vacuum and blowing compressed air to make ready for entry into our regeneration oven.
  3. Placing the unit in the oven and setting it to gradually heat up, baking the unit at 1112 degrees Fahrenheit.
  4. Unit stays in our oven at 1112 degrees for 2 hours and then gradually cools down.
  5. Total regeneration time is 8 hours.
  6. The unit is brushed and cleaned externally to ensure a thorough cleaning externally.